Fixturlaser Shaft 100, User Manual

Page: 12 / 66

12
F
IXTURLASER
S
HAFT
100
S
AFETY AND
C
ARE
P
OWER SUPPLY
The Fixturlaser Shaft 100 is powered by four alkaline batteries, size LR 20, in the
display unit or by the optional external power unit. The lifetime of the batteries is
approximately 24 hours when the system is used for a typical alignment job. The
power indicator in the main menu displays the power from the batteries. When the
power is low a battery replacement warning appears on the screen.
The batteries are replaced by opening the caps revealing the battery tubes. There are
two batteries in each compartment. The batteries should be replaced with the plus
pole pointing inwards the display unit and the minus pole pointing towards the caps.
You can use rechargeable NiCd-batteries but you should expect shorter operating
time than with alkaline batteries. If the system turns off due to low power, the system
returns, after battery replacement or connection of external power, to the application
where it was when it turned off. No information is lost!
If the system is to be stored for a longer period of time the batteries should be
removed to prevent damage.
The external power unit is connected to the terminal next to the serial port on the
display unit and to a wall socket with 110 - 240 Volts.
S
AFETY
The Fixturlaser Shaft 100 use two laser diodes with a power output of < 0,5 mW. The
laser classification is Class 2 which is considered safe for its intended use with only
minor precautions required. These are:
Never stare directly into the laser transmitter.
Never shine the laser directly into anyone else’s eyes.
Your system complies with the requirements in:
•SS-EN-60825-1-1994
•British Standard BS 4803 Parts 1 to 3
•Deutsche Industrie Norm DIN JEC 76 (CO) 6
•USA FDA Standard 21 CFR, Ch 1, Part 1040.10 and 1040.11
p-0040r2.p65 1998-01-23, 13:42 12