INSTRUCTION MANUAL
Electrical winches LM90A/LM250A
Réf : 1813000156
Page :
16/17
Version : 23/21
4.2
Optionnal radio remote control
A remote control is regarded as a control
device; its proper implementation must respect the
resulting rules. For maximum handling safety of the
radio remote control, it is recommended to respect
the instructions provided in the detailed manual (in
French, English and German).
If using multiple radio controls on the same site,
assign different radio channels (see § of the detailed
instructions).
Clearly
mark
your
pairs
of
“Transmitter/Receipter”.
In some cases, it is essential to modify and
customize the settings of the transmitter and
receiver to ensure the uniqueness of the installation.
To obtain all details for the use of the remote
control, refer to the instructions (see chapter of the
detailed instructions).
The user must have undergone suitable training, and
must be capable of driving by radio remote control.
The user must always have the visibility of the
operation that he is carrying out.
Remember to change the batteries (1.5V AAA) or
to recharge the batteries if the charge level is low.
Service the equipment, and carry out periodic
inspections depending on the intensity of use.
4.2.1
Model ref 461025
This model follows the recommendations of
EN60204-32:2008
It contains a transmitter
(IP65) and a receiver
with internal antenna
(IP66
–
range 75 to
100m).
Frequency band : 2405-
2480MHz
The receiver must be
positioned throughout the scratches on the electric
box cover of the LM.
Plug then the connector instead the pendant control.
START :
- Make sure the red STOP button is pressed
- Unlock by turning the STOP button. The upper
LED lights up (GREEN if the batteries are OK,
RED otherwise); The lower LEDs flash.
- Press the 2 START buttons simultaneously for 1
sec.
- Release; The lower LED goes out.
STOP :
- Automatic after 3 min without action;
- Press the STOP button
Your kit is preset for associated operation.
To add a Receiver / Transmitter association:
- Start the transmitter you want to associate
- Press the F button in the Receiver
- Press the S button in the Receiver
- Press the Up and Down buttons on the transmitter;
Hold while the LEDs have the following sequence:
Continuous red then 2 flashes green
- Release the Up button; The LEDs flash 1 time in
Green
Simultaneous use of 2 transmitters is not allowed.
You must disconnect the transmitter to use the
other:
- Start the transmitter you wish to disconnect
- Press the Start key on the left
- Press the stop button.
To erase all associations in the receiver:
- Press the F button in the Receiver
- Press the S button in the Receiver for 4 sec.
