VPP50 Vacuum Pickup System Operating Manual
© 2020 Fisnar
- 12 -
VPP50 Rev 01
OPERATION MODE
FIG. 6: Operation Mode
1.
Place the suction cup installed on the pick-up pen over the component and
apply a light force so there is no gap between the surface of the suction cup
and surface of the component.
2.
Position finger over the hole on the finger grip of the vacuum pickup pen and
keep held down to apply the vacuum through the suction cup.
3.
Use the vacuum control knob to increase the vacuum pressure by slowly
turning it counterclockwise to a suitable level where there is enough force to
securely seal the suction cup to the component. See FIG. 6.
This step is only required when initially setting up the machine.
Excessive vacuum pressure may cause damage to small delicate
components. Always use minimum allowable vacuum pressure.
3.
The component can now be picked up and safely positioned in the desired
location.
4.
Remove finger away from the hole on the finger grip of the vacuum pickup,
and then remove the suction cup safely away from the component.
3
