2 | Important Notes
Digital Drybath
Important Notes
General Practice
Safety
During operation, maintenance and repair of this instrument,
the following basic safety notes should be observed. In case
of failure to follow these instructions, the warnings or notes
indicated herein, the basic protection provided by the
instrument, its safety criteria of design and manufacture, and
its predicted use range would be impaired. If the equipment is
used in a manner not specified by the manufacturer, the
protection provided by the equipment may be impaired.
CAUTION:
Important information is contained in
any item and should be carefully read. Failure to
observe the instruction would result in damage or
abnormal function of the instrument.
WARNING:
The warning message requires
extremely careful operation of a certain step.
Failure to observe the instruction may result in
serious personal injury.
CAUTION:
This instrument is for indoor use.
•
The ground connection
To avoid the electric shock, the input power
line must be reliably grounded. The instrument
is equipped with the three-pin plug that has
the third pin (the pin connects the ground),
therefore, the plug should be used with the
grounded power socket only. This is a kind of
safety device. If the plug cannot be plugged
into the power socket, please ask the
electrician to install a correct power socket, so
as to make the grounded plug to work for
safety.
Fisher Scientific is not responsible for any
injury as a result of the user’s failure to
observe the following requirements.
•
Servicing and Replacement of Parts
The operator should not take the instrument
apart without permission. Only qualified
professionals are allowed to replace elements
or adjust components inside the instrument.
Replacement of components while unit is
connected to power and/or turned on is
prohibited.
•
Observe voltage/power requirements
Before the instrument is connected to the AC
power source, the voltage of the power
source should be the same with the required
voltage of the instrument (a deviation of ±10%
is allowed). The rated load of the power
socket should not be lower than the
requirements of the instrument.
•
The power cord
The instrument should use the power line cord
attached to it. If the power line is destroyed, it
must be replaced but not be repaired. The
replacement should be carried out with the
power line of the same type and same
specification (reach out to technical service
team for further information). No items should
be put on the power cord when the
instrument is in operation.
•
Connecting and disconnecting to/from
power source
The user should hold the plug to remove from
power source. When connecting the plug,
user should make sure it has been fully
plugged in; when removing the plug, do not
pull the power line forcefully. Do not position
the equipment so that it is difficult to operate
the disconnecting device (plug).
•
Placement of the instrument
This instrument should be fixed in a low
RH (
≤
80%) and low dust place away from
water source (e.g. sink or water pipeline) and
the room should be well ventilated, and free of
corrosive gas or interference of strong
magnetic field. The instrument should not be
placed in a wet or dusty location.
