Lit. No. 94196/94197/94198, Rev. 05
14
November 1, 2010
13. Install the spacer between the end of the sill and
the front of the truck bed as shown. If you do not
have a spacer, refer to the Installation Instructions
to create one.
Failure to install this spacer
could result in damage to the spreader.
14. Fasten the spreader to the truck frame using the
mounting bars and existing holes and hardware.
If there are no holes, refer to the Installation
Instructions.
MOUNTING THE SPREADER
12. To assemble the chute to the spreader:
a. Select the height for the chute assembly. The
upper chute position (using lower two slots) is
typically used for pickup truck installations.
b. Remove the extended de
fl
ector if used in the
upper position.
c. Lift the chute onto the feed gate actuator bar
and slide it down into place.
d. Align the holes in the hopper body with the
threaded inserts in the chute, and install the
pins to secure the chute to the hopper body.
e. Connect the spinner motor wiring harness.
WARNING
Spreader shall be bolted to vehicle frame. Do
not rely on the tie-down chains alone to hold
spreader in vehicle.
Mounting Bars
(Both Sides)
Extended
Deflector
