5
SETTING UP
The CZ-5 comes to you just about ready to use. The only adjustment
required is the angle of the stem. You may also wish to adjust the
width of the armrest. Take a look at the diagram above and familiarize
yourself with the parts of the CZ-5 before proceeding.
1.
Unpack your new CZ-5 carefully. Save the carton and
inserts for future storage or shipment.
2.
Take a look inside the locknut on the upper stem. Note
the yellow locking pad on the left hand side and
loosen the lock nut by rotating it fully
counterclockwise.
3.
Slip the lower stem into the upper stem. Make sure the
flat side of the stem is aligned with the locking pad
inside the locknut.
4.
Adjust the stem length (using the locknut) and the coil
angle (using the nylon wing nut) so the search coil
rests flat on the ground about 6 inches in front of, and
slightly to the right of your right foot, (to the left of your
left foot for left handers). Your arm should be straight
and relaxed, with the grip held loosely.
Drop-in battery compartments
and cable connector at rear
of housing(not shown)
Removable control
housing (belt loop on
underside of housing)
Padded arm rest
Built-in detector stand
Upper stem
Foam hand grip
Upper
lock nut
Center
section
Seven foot
search coil
cable
Lower
lock nut
8-inch Spider
search coil
Adjustable
non-metallic
lower stem
Nylon wing nut
(replacable
Duro-Neoprene
bushings, not
shown)
Figure 1.
Fisher M-Scope
CZ-5 Quicksilver
Summary of Contents for M-Scope CZ-5 Quicksilver
Page 39: ...37...
