22
1.
Once you’ve located a target, pinpoint its exact
location as in the “Pinpointing” procedure.
Since
accurate ID is dependent on accurate pinpointing,
it is recommended that you always press the
PINPOINT button rather than try to pinpoint your
target in either the Autotune or Target ID mode.
2.
Once you’ve pinpointed your target, release the
PINPOINT button. If you’re searching in the
Autotune mode, switch over to DISC = 0. If you are
already in the Target ID mode, just leave the DISC
control where it is.
3.
Move the coil just enough, left right left, across the
target to get a good signal. The meter needle
should lock onto a target classification, which in
turn will agree with the audio response (high,
medium, or low tone).
4.
If you no longer get a meter reading or audio
response once you’ve pinpointed the target, then
you’re over something that falls below the DISC
setting you’ve chosen and the CZ-5 is rejecting it.
5.
Here’s a quick and easy way to tell the difference
between a small shallow piece of foil and a gold
ring (or other possibly good target) without digging:
if you get a good solid, “FOIL” ID, set the search
coil down close to the target and then whip it
rapidly across the target just once with what can
best be described as a flick of the wrist. If the target
disappears, it’s probably a small shallow piece of
foil. If not, dig it up—it could be that gold ring you’re
looking for. Practice this over some foil until you
get the hang of it.
6.
Don’t be afraid to turn your sensitivity down. True,
the higher the sensitivity, the deeper your CZ-5 will
go and the more you’ll find. But that’s only under
optimum conditions. If you’re getting a lot of false
signals caused by electrical interference, ground
mineralization or dense trash, lower your sensitivity.
If you have to back it down to 4, 3 or even 2 to
eliminate the falsing, do it. That’s what your
TARGET IDENTIFICATION
Summary of Contents for M-Scope CZ-5 Quicksilver
Page 39: ...37...
