FACTORY PRE-SET “TURN-ON-AND-GO” MARKS
Your CZ-5 QuickSilver is fairly simple to operate, especially when
compared to other target ID machines. Even so, we strongly
recommend that you read this entire manual. You’ll be able to tune
your CZ-5 to your specific needs and conditions. If you have a good
understanding of how to do it and why, you’ll find more.
If you can’t wait any longer, and you’re an experienced detector
user, here’s some quick instructions to get you going:
1.
Set all the controls to the red “Turn-On-And-Go” marks:
GROUND = 5
DISC
= 4
SENSITIVITY = 2
MODE
= NORMAL
VOLUME
= 5
This puts you in a “coins-only” mode and you’re ready
to start searching. Keep in mind that the GROUND
setting of 5 is probably not the optimum setting for
the ground you’re searching and that’s why the
sensitivity level is set low—to reduce false signals
caused by ground mineralization.
2.
If you’re using headphones, adjust the volume controls
for a comfortable volume when the coil is passed over
a large shallow object.
3.
Walk slowly, overlap your sweeps and keep the search
coil moving. Remember you are in a “motion” search
mode and the coil must be moving at least slightly to
detect a target.
4.
When you get a good, repeatable signal, pinpoint
the target by placing the coil on the ground away
from the target, pushing and holding the pinpoint
button and then bringing the coil back over the target.
5.
Once you’ve pinpointed the target, note the
approximate depth reading on the meter, then
identify it by releasing the pinpoint button and moving
the coil side to side in short strokes over the target. The
meter needle will lock onto the appropriate target
classification.
6.
Good Hunting.
CONDENSED OPERATING INSTRUCTIONS
4
Summary of Contents for M-Scope CZ-5 Quicksilver
Page 39: ...37...
