Isotemp Economy Incubators
Page 10
Replacing
The Glass
Door
The Isotemp 500 Series incubators feature a glass door to allow the
chamber to be viewed with minimal heat loss. Should the glass door
become damaged, it may be replaced by following the procedures
below.
1.
Loosen the set screws on outside of upper and lower hinges of the
glass door.
2.
Remove old glass door and set aside.
3.
Generally reverse steps above to install replacement glass door.
Adjust hinge position until gap between door and frame is roughly
equal on all sides.
Allow incubator to cool to ambient temperature
before attempting repair.
Caution:
While loosening hinge set screws, continue to
grasp the glass door. When the set screws are
loosened, the door is freed and will fall out if not
held.
Caution:
Summary of Contents for Isotemp 500 Series
Page 2: ......
Page 7: ......
Page 23: ...Page 19 Isotemp Economy Incubators Electrical Schematic ...
