Fisher Scientific Fisher Sei 100L Gravty, Operation Manual

Page: 30 / 63

| Start-up
22
|
50145736 Fisherbrand
Chapter 5
1. Loosen the two screws [1] in the bottom panel, then remove the entire bottom panel by lifting
it out of its two embossings.
Figure 5-5. Bottom Panel Removed
2. Grab the two retaining springs [1] at their tabs and pull them downwards out of the
embossings, then pull off the lateral air baffle.
Figure 5-6. Removing the Lateral Air Baffle
3. For the lateral air baffles to install correctly, the two retaining springs [1] must be facing
upwards. Place the lateral air baffle on the lower embossings and tilt it upwards against the
side wall of the work space.
4. Clamp the two retaining springs [1] into the upper embossings.
5. Replace the bottom panel into the embossings and secure it by fastening the two screws at [1].
Risk of damage to sensor!
To prevent accidental damage, be sure to avoid collision with the sensor when
installing or uninstalling panels in the oven‘s workspace.