J7825a-0920
3
4
1
11
H
J7825a-0920
BATTERY INSTALLATION
IMPORTANT!
Use only a Power Wheels
®
6 volt (4.0 Amp/Hr.)
battery and built-in thermal fuse. Use of any other battery will
damage your vehicle. Make sure that you charge the battery for
at least 18 hours using the enclosed Power Wheels
®
6 volt
(4.0 Amp/Hr.) charger before operating your vehicle for the first
time. Charge the battery for at least 14 hours after each use of the
vehicle. Never charge the battery longer than 30 hours. Failure to
follow these instructions may damage your battery and will void
your warranty.
2
• Loosen the screw in the battery retainer and remove it.
• Locate the lock fastener in the back end of the seat.
• Using a slotted screwdriver, turn the lock fastener 1/4 turn to the
unlocked position
.
• Lift the seat from the vehicle.
Battery
Retainer
Lock
Fastener
Seat
Unlocked
6 Volt
Battery
Battery
Compartment
Battery
Retainer
Battery
• Fit the Power Wheels
®
6 volt (4.0 Amp/Hr) battery inside the battery
compartment with the wires facing towards the rear of the vehicle.
• Place the battery retainer over the battery.
• Replace the screw through the end of the battery retainer and into
the vehicle.
• Tighten the screw with a Phillips screwdriver. Do not over-tighten.
