1
2
Assembly
Right Base Wire
Feet Holes
Footrest Wire
Base Tube Holes
• Position the feet so the holes are toward you and the non-skid
surface is down.
• Fit the feet on the base tube, as shown.
IMPORTANT!
Before assembly and each use, inspect this product
for damaged hardware, loose joints, missing parts or sharp
edges. DO NOT use if any parts are missing or broken. Contact
Mattel for replacement parts and instructions if needed. Never
substitute parts.
• Place the base tube on a flat surface, with
the holes facing you
.
• Position the left and right base wires as shown.
• Fit the left base wire and right base wire into the base tube.
Left Base Wire
3
3
• Insert an M5 x 20 mm screw through each foot and tighten.
M5 x 20 mm Screw - 2
4
• Place the liner on a flat surface with the soother unit facing you.
• Lift the footrest wire and rotate it toward you until it is on
the surface.
• Turn the liner over so that the soother is upright.
Liner
Soother Unit
Soother Unit
