5
Assembly
5
Base
Plug
“T” End
• Bend the “T” end of the plug and insert it into
the hole in the base.
Note:
After assembly is complete, fill the base
with water or approximately 50 lbs. (22,7 kg)
of sand (water and sand not included) to keep
this product stationary. Simply lift the plug,
fill the base, and replace the plug.
6
4
5
6
Curved End
Upper Post
Base
Large Square
Opening
• Position the base as shown.
• Position the upper post so that the straight
end is down and the curved end is up and
facing away from the base.
Hint:
For easier assembly, apply liquid soap
or rub a candle or bar soap around the bottom
of the upper post (especially on the corners)
and the inside of the large square opening.
If assembling inside, place a tarp under the
base to protect the floor surface.
• Insert the upper post into the large square
opening in the base and, using a circular
motion, push it all the way down.
7
8
4
5
6
Rectangular Tab
Rim
Upper Post
• Hook the rectangular tab on each side of the
rim to the upper post, as shown.
• Rotate the rim down until it snaps into place
on the upper post. Push down on the rim to
be sure it is secure.
6
4
5
Backboard
Labels
Groove
Wall
Rim
Peg
Upper Post
• Lean the rim against a wall for support.
• Locate the pegs on each side of the rim and
the grooves on the backboard.
• Position the backboard with the label side
facing up.
• Place your foot on the base to hold it steady
and slide the backboard onto the upper post
at an angle, as far as it will go.
Note:
There should be no gap between the
upper post and the backboard.
• Move the assembly away from the wall.
