4
Assembly
Groove
Ring
Ring Tab
3
1
2
• Place the loops at the top of the net into the
grooves on the ring.
• Pull each loop through a ring tab, as shown.
Rim
Net Assembly
Rectangular Tabs
• Place the rim on a flat surface with the
rectangular tabs facing up.
• Locate the four screw holes on the underside
of the net assembly.
• Align the four screw holes on the underside
of the net assembly with the four holes in
the rim.
• Place the net assembly onto the rim.
Rim
• While holding the ring assembly and rim
together, turn them over.
• Insert four screws into the rim.
• Partially tighten the screws with a Phillips
screwdriver. Turn the rim over to ensure
that the net loops are still in the grooves
and through the ring tabs before completely
tightening the screws. Do not over-tighten
the screws.
4
3
2
4
5
1
Side Edge
Side Edge
• Wipe the backboard with a clean, soft, dry
cloth to remove any dust or oils.
• Peel the backing from one half of label 1.
Do not remove all of the backing!
• Align the side edge of label
1
(where backing
is removed) with the side edge of the label
area on the backboard and apply.
• While rubbing the label in place, continue to
peel the backing from the other half of
the label.
• Apply the remaining labels to the backboard.
Labels
2-5
are designed to overlap.
• Dispose of the label backings properly.
