September 6, 2001
4
Lit. No. 26469
9828-2
1. Attach the mounting brackets to the valve block
with two 1/4 x 3" cap screws, flat washers and
locknuts.
2. Tighten cap screws.
ATTACH HYDRAULIC FITTINGS TO
CYLINDERS
ATTACH MOUNTING BRACKETS TO
INSTA-ACT
®
HYDRAULIC POWER UNIT
Angle Cylinders
1. Remove threaded plugs from cylinders using an
Allen wrench.
2. Attach fittings (street elbows) to angle cylinders as
shown. Fittings must be oriented to direct hoses
parallel to cylinders. Do not use thread sealant/tape
on hoses or fittings. This could damage product.
3. Attach 36" hoses to fittings in angle cylinders.
1/4 NPT x
90° Street
Elbow
1/4 NPT x
90° Street
Elbow
1/4 NPT x
90° Street
Elbow
1/4 NPT x
90° Street
Elbow
Passenger Side Angle Cylinder
Driver Side Angle Cylinder
Angle Cylinder Fittings
Hoses parallel to
cylinder.
Lift Cylinder Fittings
9/16 O-Ring to
1/4 NPT 90° Elbow
Mounting
Brackets
Hydraulic
Unit
Locknut
Flat Washer
1/4 X 3" Cap Screw
Flat Washer
