4
Prior to installing your coffee maker, ensure the following:
z
The countertop and coffee maker cavity are square and level, and are the
required dimensions.
z
The installation will comply with all clearance requirements and applicable standards
and regulations.
z
The isolating switch will be easily accessible to the customer with the coffee
maker installed.
z
The electrician provides sufficient free length of power supply cable to reach from
the bottom rear of the cavity to at least 59 1/16” (1.5m) in front of the bottom edge of
the opening.
z
The cable may enter the cavity from the side, top or bottom, but top entry must be at the
rear of the cavity.
z
The coffee maker connection socket (if fitted) is outside the cavity if the appliance is flush
to the rear wall.
z
The coffee maker will rest on a surface that can support its weight.
z
The height from the floor suits the customer.
z
You consult local building authorities and by-laws if in doubt regarding installation.
WARNING!
Some environmental factors and cooking habits can cause condensation in and around the
coffee maker during use. To protect surrounding cabinetry from possible damage caused by
frequent or excessive condensation, we recommend moisture-proofing the oven cavity.
During installation, please ensure the following:
z
The coffee maker can be used fully without obstruction.
z
The power supply cable does not touch any hot metal parts.
z
The isolating switch is easily accessible to the customer with the coffee maker installed.
z
You complete the ‘Final checklist’ at the end of the installation.
z
If, after following the instructions given, correct performance cannot be achieved, please
contact your nearest Fisher & Paykel Service Centre, Customer Care, or contact us through
our local website listed at the end of this document.
WARNING!
Take extra care not to damage the lower trim of the coffee maker during installation.
The trim is important for correct air circulation and allows the coffee maker to move
without obstruction.
The manufacturer does not accept any responsibility for damage resulting from
incorrect installation.
z
The coffee maker must be installed in a column and the column must be firmly fixed to the
wall with commercially available brackets.
z
The cabinet material must be able to withstand heat.
z
To guarantee correct ventilation, leave a gap in the cabinet according to the measurements
under cabinetry dimensions.
COMPONENTS REQUIRED
INSTALLATION CONSIDERATIONS
z
Keep all packing materials until the unit has been inspected.
z
Inspect the product to ensure there is no shipping damage. If any damage is detected
contact the dealer or retailer you bought the product from to report the damage.
z
Fisher & Paykel is not responsible for shipping damage.
Not supplied
Crosshead
screwdriver
Power drill
Scissors
Supplied
Mounting screws
(28)
Spacers
(4 for side)
(4 for bottom)
Rails (2)
Clip (1)
Side trims (2)
Lower trim (1)
Side/lower trim
screws (10)
3mm hex
key (1)
PRIOR TO INSTALLATION
DURING INSTALLATION
PARTS SUPPLIED
TOOLS REQUIRED
