- 70 -
12.6
SHAFT & BEARING ASSEMBLY
1.
The bearings must be inserted separately with the
inner bearing fitted first
and pulled down with the
bearing tool onto the shoulder in the bearing housing.
IMPORTANT
: There must be no gap
between the bearing outer race and the shoulder of the aluminium extrusion. Remove the insertion
tool at this point and check that the inner bearing is fully home.
2.
Fit the bearing spacer and press in the outer bearing using the bearing tool. Check the spacer has no
end float but has slight sideways movement to allow for shaft insertion.
Summary of Contents for LW015
Page 11: ... 6 4 0 SMARTDRIVE COMPONENTS ...
Page 13: ... 8 PHASE 5 WIRING DIAGRAM ...
Page 39: ... 34 ...
