517804 D
35
9.5
Water Valve Replacement
•
Ensure the water is turned off at supply tape.
•
Disconnect the refrigerator from the power supply.
•
Pull the product away from the wall to access the rear of the product.
•
To remove the water tube from the water valve, push the inner part of the clip inwards and hold
down while pulling the tube from the valve. Drain the water (approximately 1½ litres) into a
container.
•
Remove the RAST connector from the water valve.
•
Remove two screws holding the valve to the back wall of the unit compartment.
•
Refit in reverse order.
9.6
Display Module Replacement
The display module is located on the front of the door.
To remove the module:
Step 1
Disconnect the refrigerator from the power
supply.
Push the tabs upwards and gently pull the panel
forward once the tabs release.
A small screwdriver or key may need to be used
to dislodge the tabs from the housing.
Step 2
Two locating pins on the base of the front panel
hold the housing at the bottom.
Note: The housing cannot be removed as
wiring looms prevent the housing being
removed.
Step 3
Disconnect the RAST connectors from the
module.
Pull the two bottom tabs forward.
Remove the module.
Locating pins
