34
8.15 Removing the Water Valve
•
Remove the product from the joinery.
•
Remove the inlet hose to the water valve.
•
Remove the 2 screws securing the inlet valve to
the frame at the rear of the product.
•
Remove the base panel from the machine, and
disconnect the flood switch assembly to remove
the base panel completely.
•
Remove the supply hose and wiring harness from
the water valve.
•
Reassemble in reverse order, and ensure the inlet
hose is tight on the valve and not leaking.
8.14 Removing the Controller
•
Remove the product from the joinery.
•
Remove the right hand side panel, refer section
8.3.
•
Remove the bracket securing the mains cable
and remove the cable from the controller.
•
Remove the controller securing screw through
the chassis rail, and remove the earth harness to
allow the controller to be pulled out far enough
to gain access to the wiring harnesses.
•
Remove the wiring harnesses at the front of the
controller.
•
Open the top of controller by releasing the tabs,
and disconnect the wiring harnesses.
•
Unplug the mains cable at the rear of the
controller.
chassis
screw
Tabs
main cable
bracket
8 SERVICING THE COMPONENTS
D
D
NOTE: There are controller differences between
models, so important you order the correct
controller part number from the product parts
manual.
