Fisher & Paykel DISHDRAWER DD60STX6HI1, Installation Manual, Page: 15 / 20

15
FIT THE CUSTOM PANEL
2
6
3 7
4
8
Carefully pull the bracket out from
DishDrawer™ Dishwasher and unplug the
Knock-to-Pause module and earth wire.
Remove the Knock-to-Pause module
from the back of the bracket.
Reconnect the Knock-to-Pause model
and earth wire to the DishDrawer™
Dishwasher.
Attach the Knock-to-Pause module to
the panel as shown.
Ensure the Knock-to-Pause module is
oriented correctly and is not in contact
with the bracket before securing.
On the back of the panel, mark the
centre and align the base of the bracket
with the base of the panel.
Re-insert both side pins to secure the
panel in place.
Secure the bracket to the panel using a
minimum of 3 screws on either side.
Insert a screwdriver into the hole above
the side pin and rotate to adjust the
panel alignment. There is a maximum
travel distance of ± 2mm.
Repeat on the other side if required.
Ensure the minimum clearance gap of
2mm is maintained.
1
5
Remove both side pins from the drawer.