Mounting Dryer on Wall
1. Determine the position of the dryer on the wall
and mark the bracket position. A minimum of
50mm is needed between the top of the dryer
and the ceiling for ease of installation. If
mounting above a washing machine, allow
sufficient room to open the lid of the washer.
Refer to page 10
for lid clearances.
2. Fix the wall hanging brackets to the wall
securely, eg into the stud. If the studs are too
far apart, fit a timber slat to the studs and then
mount the brackets onto the slat. Add the same
slat under the two spacers. The distance
between the centre of each bracket is 555mm
(
A
).
3. To install the hooks onto the dryer, remove one
screw from each side (
B
), reuse these with two
more (each side) from the kit to fasten the
hooks in place.
4. Remove plastic plugs from the back of the dryer
and screw the spacers provided in place (
C
).
5. With assistance, mount the dryer on the
wall brackets.
Before a rear venting option is installed the dryer must be changed from the front venting factory setup. Remove the
outlet grille from the front left-hand side and replace with the outlet cover from the rear left-hand side. These covers
should be gently pried at the sides to prevent damage.
Updated: Mon, 05 Oct 2020 18:08:12 GMT
Powered by
8
