11
Before a rear venting option is installed the dryer must be changed from
the front venting factory setup. Remove the outlet grille from the front
left-hand side and replace with the outlet cover from the rear left-hand
side. These covers should be gently pried at the sides to prevent damage.
External venting options
●
●
The dryer can be vented with a kit that can be positioned to vent
upwards or to the side. Kit part number PD-DK4W.
●
●
The dryer can be vented directly through the wall with Kit part
number PD-SVHCW4, in combination with the duct adaptor supplied
with the dryer.
Note:
the vent system should be a maximum of 2 metres with no more
than three 90⁰ bends.
Internal venting
Front venting is the only option for internal venting. The dryer is set up
for front venting when it leaves the factory.
Note:
all efforts should be made to vent the dryer externally, if possible,
to avoid moisture build up in the area around the dryer.
Electrical connection
1
This appliance must be connected to a 220 V – 240 V, 50 Hz,
sinusoidal, 10 A electrical supply.
2
Uncoil the power cord, remove and discard the plastic pin cover and
plug into a power socket.
3
Connect the appliance to an earthed outlet protected by a fuse of
suitable capacity.
●
●
Check the power cord for damage and make sure it is not squashed or
twisted when installing the dryer.
●
●
Always remove the power cord from the power socket
by the plug, not by the cord.
IMPORTANT!
●
●
Do not touch or operate the dryer with wet hands or with bare-feet.
●
●
A damaged power cord must be replaced by a Fisher & Paykel
Authorised Repairer. The appliance must not be operated until it is
repaired, as there is risk of electric shock.
●
●
Do not operate this dryer if it has been damaged during transport.
Contact your Fisher & Paykel dealer or Fisher & Paykel Authorised
Repairer.
