Fisher & Paykel AeroCare DE7027G1, Installation Instructions And User Manual

Page: 80 / 92

78
Before you call for service
User warnings
Your dryer is capable of diagnosing a number of its own problems. A continuous series of beeps
will sound and a code will be displayed when it has a problem that you can correct yourself. All
control panel lights will turn off and a code will be displayed to inform you what the problem is.
To stop the beep sounding, press any button on the control panel. Do not try to continue your
drying cycle once you stop the noise. You must address the problem the dryer is alerting you to.
Check this chart before you call for service.
Description Displayed as What should you do?
The door is
not closed Close the door fully and touch START/PAUSE.
Try opening and closing the door again.
Reposition the load, make sure the load is correctly in the
drum and that no items are caught in the way of the door.
Once you have addressed the issue the user warning was alerting you to, try using your dryer
normally.
If the symptom persists, call your Fisher & Paykel Authorized Service Agent (refer to page 86).
Fault codes
When a continuous series of beeps is sounded, all the lights turn off on the control panel and a
number appears on the display; a fault has occurred. The dryer will automatically enter this mode
if a fault occurs. The fault code will be displayed as a number on the digital display. To stop the
sound, touch any button and perform the following steps:
1
Unplug your dryer from the power outlet.
2
Wait one minute and plug the dryer back in.
3
Check the dryer is correctly level (refer to page 44).
4
Remove your dryer load and retry.
5
Perform a TIME DRY cycle (20 mins).
6
If the fault re-occurs repeat steps 1 and 2.
7
If the machine still will not work you will be required to call a Fisher & Paykel Authorized Service
Agent to arrange service (refer to page 86). Record the fault code number displayed and the
serial number of your dryer (located on the drum opening surround (open the door)) before
calling. The fault code will indicate to the Service Agent what the problem could potentially be.
If a fault code is being displayed, you can still turn your dryer off by pressing POWER.