Fisher & Paykel AD55 Series, Service Manual, Page: 16 / 28

- 15 -
SERVICE PROCEDURE
AD55
WARNING : Before dismantling this dryer,
remove 3-pin plug from wall outlet socket.
ED55/56
WARNING: Before attempting to service
or adjust any part of the machine,
disconnect the electrical power supply
from the wall outlet.
The console power switch DOES NOT
isolate the mains voltage from the
machine.
ELECTROSTATIC DISCHARGE SENSITIVE
DEVICES:
Any competent bearing the above label is
subject to damage by electrostatic discharge
while being handled. Care must be taken
when handling the parts to prevent accidental
contamination.
Use anti static wrist strap
GROUNDED
TO EARTH
Printed circuit boards removed from the
machine for return must be protected from
possible
electrostatic damage (ESD) while in transit by
the use of specialised packaging provided.
Stage A – To Remove Timer
Knob (AD55 only)
1. Grip firmly and pull forward. Note: Push
fit only
2. Replace by matching flat on the timer
shaft to corresponding flat in knob insert.
Push firmly into place.
Stage B – To Remove Control
Panel
Complete Stage A then –
With the door closed
1. Remove one screw from either side of
panel concealed on underside.
2. Open door – remove remaining screw
located in control panel above door.
3. Tilt panel forward from lower edge. Pull
down gently.
NOTE: Panel has 6 retaining lugs along the
top edge to locate it to trim.
Reassemble to reverse order.
Stage C – To Remove Top trim
Complete Stages A & B then:
1. Remove 2 screws from front of trim
previously concealed by panel.
2. Remove 5 screws from rear of trim.
Reassemble to reverse order.