5 | Operation
FISCHER Mess- und Regeltechnik GmbH
52/108
BA_EN_FT90
5.5 Configuration
The device can also be configured with the
inTouch®
software on a PC. The
finished parameter set is then transferred to the FT90 via the USB interface.
WARNING
Configuration in potentially explosive areas
The housing may not be opened within the ATEX area. This means that config-
uration and firmware updates via the USB interface are only possible outside
the potentially explosive area.
Path: \Configuration
Level: 1
\Configuration
Channel 1
Channel 2
Channel 3
Analogue output
A
A
U
A
A
1
2 3
4
Fig. 71:
Configuration
The parameters and menus are described for a device with three channels. The
displays and descriptions may vary in the case of a device with two channels.
Menu name
Description
Channel 1
A
The 1st measuring channel is con-
figured with this menu.
Channel 2
A
The 2nd measuring channel is con-
figured with this menu.
Channel 3
A
The 3rd measuring channel is con-
figured with this menu.
Analogue output
A
The analog outputs are configured with
this menu.
Switch output
A
The switch outputs are configured with
this menu.
Display
A
This display is configured with this
menu.
Modbus RTU
A
This menu is available for Modbus
devices only. It enables the configura-
tion of the interface.
Back
E
This is the exit point of the configura-
tion menu. It takes you back to the
main menu.
Signposts [►Page]
•
•
•
•
•