2
Actuators and Connections Front Side
Description of the actuators (front side) :
(1)
On/Off Switch with LED
When the operating voltage of the amp is switched off, the Amp still
consumes a power of minimum 2 watts. Therefore we recommend that
the Amp is disconnected from the mains supply, if not used for a longer
period of time.
(2)
Earphones Output
Earphone connection for the Fischer Amps Guitar In Ear Cable or XLR
male 3-pole: to connect a symmetric standard microphone cable in
combination with the Mini XLR Body-Pack. The use of microphone
cables allows musicians to perform in distance from the In Ear Amp.
Even the transmission of the earphone signal through a multicore or
sub-multicore is very easy without the need for an adaptor.
(3)
Earphones Output
Direct connection of earphones to the In Ear Amp. For use with 1/8”
stereo connector 1/4“
mini connector in ear earphones, an adaptor and a 2m extension cord is
included in the In Ear Amp package.
The two earphones outputs are switched in parallel, and – as long as
the connecting impedance of 10 ohms will not be exceeded – can be
used together. The maximum output power is 80mW per side.
IMPORTANT:
The stereo jack may only be operated with a stereo earphone set with stereo jack
connector. When using a mono jack connector, the right side of the amplifier is
short-circuited permanently and is overloaded.
(4)
Volume Control
Adjusts the total volume at the earphones outputs.
Earphones Output
This volume control is switched after the limiter unit. When the Mini
Body Pack with passive volume control is connected, the maximum
volume required should be adjusted at volume control (4), as the
volume can be set to the optimum hearing level at the Body Pack.
Summary of Contents for In Ear Amp
Page 5: ...5 BLOCK DIAGRAM FISCHER AMPS IN EAR AMP ...
Page 7: ...7 Notes ...
