ALARM TRIGGER EVENT
LED FLASHES
Door, Hood, Trunk, or Ignition On triggered
2, Pause, Then Repeat
Full triggered shock sensor
3, Pause, Then Repeat
Optional sensor triggered
4, Pause, Then Repeat
Panic Mode
5, Pause, Then Repeat
PARKING LIGHT FLASHES
REMOTE START ERROR
3 then 1
1: Motor running
3 then 2
2: Key in ignition on position
3 then 3
3: Door open
(manual transmission only)
3 then 4
4: Trunk open
3 then 5
5: Foot brake on
3 then 6
6: Hood open
3 then 7
7: Reservation off
(manual transmission only)
3 then 8
8: Tach or voltage sensing failure
3 then 9
9: FT-DAS sensor shutdown
3 then 10
10: System is in Valet Mode
ALARM LED CODES
START ERROR CODES
If you have an alarm and optional LED(s) installed, it will flash once
a second if armed. If your alarm is triggered then the LED(s) will flash
more than once until it is disarmed. See the table below for what
each LED code represents.
Valet Mode: If your remote start is not working, you may be in Valet
Mode. Your parking lights will also not flash. Your doors will still
lock and unlock. To exit Valet Mode, tap the Lock and Trunk buttons
or turn the Ignition On and then tap the foot brake 10 times or
reprogram your remote(s).
To reprogram your remote first cycle the key in the ignition 5 times
within 7 seconds. Parking lights will flash. After that tap the Lock
button on your remote. Repeat for any additional remotes. If you
receive two parking light flashes, your system has exited remote
programming mode and you must retry.
Register online at www.compustar.com within 10 days of
purchase to activate your new remote’s warranty.
Questions/comments? Contact us at 888-820-3690 from 8
AM to 5 PM PST. Also please visit www.compustar.com for a
complete user’s manual.
1W4B_QuickCard 130611.indd 2
2013/6/11 16:50:29
QUICK START CARD
RF-P1WG15R-FM
