First Light C-BLUE One, User Manual

Page: 32 / 67

32
In case of multiple errors, there shall be at least
two green
Flash_12_5
pulses before the next
error is indicated.
Connection test packets being sent AlternateFlash_0_5 green / orange
The timings associated to these states are summarized in the table below.
Table 17 – Connector indicator lamp timings
Indication
Frequency
(±20%)
Duty Cycle (on) (±20%)
Flash_12_5
12.5 Hz
25% (20ms on, 60ms off)
Flash_1 1 Hz
25% (200ms on, 800ms off)
AlternateFlash_12_5 12.5 Hz
25% (20ms on color 1, 60ms off, 20ms on color 2, 60ms off)
AlternateFlash_0_5 0.5 Hz
50% (1s on color 1, 1s off, 1s on color 2, 1s off)
CoaXPress® supported functionalities
The main functionalities offered by CoaXPress® and supported by the C-BLUE One camera are the
following:

CoaXPress® 2.0. This enables to reach the maximum frame offered by the sensor.

Mono8 and Mono12 pixels formats. Note that Mono10 is not supported.

One stream. The camera sends one image at the time.

CoaXPress® speeds:
o
Discovery rate: CXP-3
o
Operation rate: CXP-10

Heartbeat. A timestamp is sent regularly to enable synchronizing the PC time with the camera time.
Note that event messages are not supported by the camera.

Connection test uplink and downlink. This feature enables testing the CoaXPress links.
Power-over-CoaXPress
®
The camera can be powered by Power-over-CoaXPress
®
(PoCXP).
The available power is 13W per cable with 24V DC.
The two cables must be connected to the camera for PoCXP use.
If the LEMO® power connector is connected, PoCXP is automatically disabled on the camera.
The camera can shut down if the external power supply LEMO® connector is plugged
while using PoCXP.
Note: When the power LEMO® connector is not used, the camera remains turned off until the second
CoaXPress
®
cable is connected.