22
Troubleshooting
Fault
Probable Cause
Solution
Water changes color
or becomes cloudy.
Rower is in direct
sunlight or has not had
water treatment.
Change Rower location to reduce direct
exposure to sunlight. Add water treatment
or change Tank water as directed in the
water treatment section of this manual.
Consider using distilled water to refill Tank.
Rowing stroke return
is too light.
Bungee not under enough
tension.
Rowing Belt missing one
wrap around Rower belt
pulley.
Bungee has slipped off
the Bungee Pulley Wheel.
Cut Bungee Tie Rack and tighten slightly on
Bungee Hook.
Computer screen
illuminates, but does
not register when
rowing.
Loose or failed
connection/Sensor gap
too wide (see erratic
computer display).
Check that the computer lead is connected
properly. If connected properly check Sensor
gap. Contact your local service center if this
fails to address the problem.
Rowing Belt can’t
extend to the end of
rowing stroke or no
resistance.
Rowing Belt needs to be
unwrapped 1 turn or,
requires an extra wrap
on the Rower Belt Pulley
The Rower computer
does not illuminate
after battery
installation.
Batteries installed
incorrectly or need
replacing.
Reinstall batteries in correct position and try
again. If the LCD screen fails to illuminate,
try rotating the batteries slightly in the
computer. If this fails, contact your local
service center.
The Rower computer
display is erratic
while displaying SPM
and 500meter times.
Gap between Sensor and
magnetic ring is too
wide.
The Bluetooth
Auto-Adjust Monitor
LEVEL is not
synchronized with
the Tank LEVEL.
Bluetooth Auto-Adjust
Monitor LEVEL needs to
be recalibrated.
Please refer to "Calibration Procedure" page
19 of this manual.
Remove large service cover and check gap
between Sensor and magnetic ring (should be
no more than 2.5mm).
