13
Water Treatment Procedures:
Add Water Treatment Conditioner
.
Note: The amount of water treatment can vary widely depending on the Fluid
Rower’s location and exposure to sunlight. DO NOT, UNDER AN CIRCUMSTANC-
ES USE ANY TREATMENT TABLETS OTHER THAN THOSE SUPPLIED WITH
YOUR ROWER. Your Fluid Rower box contents include 4x Water Treatment Con-
ditioner, which is sufficient for several years of water treatment. Treat when water
becomes discolored or shows signs of Algae/Bacterial growth. To purchase addi-
tional Water Treatment Conditioner, please consult your nearest regional
dealer/distributor or check our website at
www.firstdegreefitness.com
Tank Filling and Water Treatment
1. Remove Rubber Fill Plug from the top of the tank.
2. Place a large bucket of water next to the Fluid Rower and position siphon with
the rigid hose in the bucket and the flexible hose into the tank as shown. Note:
Make sure small breather valve on the top of the siphon is closed before filling.
Note:
Where water quality is known to be poor, FDF recommends the use of
distilled water.
3. Begin filling tank by squeezing siphon. Use Level Gauge Decal on side of tank to
measure volume of water in tank. Important: Do not overfill tank!
4. After filling tank to the desired water level, open the valve on the top of the
siphon to allow excess water to escape.
5. Ensure that Tank Plug is replaced once filling and water treatment procedures
are complete.
Tips on Siphon use
: Putting the fill bucket higher than the tank will allow the
siphon to "self-pump" when adding water to the tank.
Tank plug
Siphon
Fill tank
with
adjuster
handle set
to “MAX”
only.
Tank Filling and Water Treatment Pro-
cedures
Note:
17 liters of water is required for
maximum filling.
Caution:
Use a drop cloth under the tank when filling the tank to avoid
staining floor or carpet.
Summary of Contents for DaytonaChallenge AR
Page 1: ...Owners Manual ...
