Step 5
Mount New Base
1) Gently separate the display from the base by pulling first from
the bottom and then the top until the two pieces unsnap.
2) Position the base against your wall, and
determine if wall anchors from current
thermostat align with screw locations of
new base.
3) If base does not align with existing anchor
holes, mark new screw locations with a pencil.
Drill 3/16" hole for the anchor
Drill 7/32" hole for the anchor
4) Pull wires through opening in base and
secure to the wall using provided screws.
TIP:
Use a level to ensure
thermostat is properly aligned
before marking screw locations.
Drywall
Plaster
Step 4
Remove Current Backplate
Unscrew the current backplate and remove it
from the wall. Be careful not to let the wires fall
into the wall.
TIP:
Wrap the wires around
a pencil or pen to keep them
from falling inside the wall.
REMOVE THE THERMOSTAT BACKPLATE:
Using the Finger Pull Areas, pull the
front housing away from the backplate.
PULL OUT WITH THUMBS IN THESE AREAS.
Backplate
Faceplate
Installation Instructions
7
