English
Page 23
Support: [email protected]
NOTE:
When the fuel selector switch is turned
to the “
LPG”
position, the indicator light will
become
RED
up to
4 minutes
(before goes off).
Starting the engine successfully during these
4 minutes
will turn the indicator light
GREEN
.
6. Disconnect all electrical loads from the
generator. Never start or stop the generator
with electrical devices plugged in or turned
on.
7. Move choke lever located on engine to “
START
”
position.
3
sec
.
See
Indicator light
-
Battery power Saving
Mode
section for more information.
REMINDER:
MUST HAVE
SOLID RED INDICATOR
LIGHT
TO BE ABLE TO START THE GENERATOR.
THE GENERATOR CANNOT BE STARTED DURING
BATTERY POWER SAVING MODE
UNLESS
THE FUEL SELECTOR SWITCH IS TURNED TO
THE “
OFF
” POSITION AND THEN TURNED
BACK TO THE “
LPG
” POSITION.
9. Move the choke lever to the “
RUN
” position.
4. Fully open the LPG
cylinder knob
.
5. Turn the fuel selector switch to “
LPG
” position.
9. Allow generator to run at no load for few
minutes upon each initial start-up to permit
engine and generator to stablize.
Starting the Generator (Electric Start-LPG)
1. Before starting the generator, check for loose
or missing parts and for any damage which
may have occurred during shipment.
2. Check oil level .
3. Connect the regulator to both LPG cylinder and
generator.
NOTE
:
Do
not
place
LPG
cylinder
in
the
path
of
muffler
outlet
.
8. Move the choke lever to the “
RUN
” position.
8. Flip the engine switch to the "
START
"(
l
) position
for few seconds and then release.
l
