English
Page 21
Support: [email protected]
4. Fully open the LPG
cylinder knob
.
5. Turn the fuel selector switch to “
LPG
” position.
3. Connect the regulator to both LPG cylinder and
generator.
NOTE:
When the fuel selector switch is turned
to the “
LPG”
position, the indicator light will
become
RED
up to
4 minutes
(before goes off).
Starting the engine successfully during these
4 minutes
will turn the indicator light
GREEN
.
6. Disconnect all electrical loads from the
generator. Never start or stop the generator
with electrical devices plugged in or turned
on.
7. Move choke lever located on engine to “
START
”
position.
NOTE
:
Do
not
place
the
LPG
cylinder
in
the
path
of
muffler
outlet
.
9.Move the choke lever to the “
RUN
” position.
11. Allow generator to run at no load for few
minutes upon each initial start-up to permit
engine and generator to stablize.
8.
PULL TO-PRIME:
-
Pull the starter cord 1-2 times. Pull slowly until
resistance if felt and then pull rapidly.
10.
PULL TO RUN:
-
-
Pull the starter cord slowly until resistance if felt
and pull rapidly to run the unit.
If the engine fails to start in 1-2 pulls with choke in the
“
RUN
” position, then move choke lever to “
START
”
position and repeat the “
PULL-TO-PRIME
” step.
REMINDER:
MUST HAVE
SOLID RED INDICATOR
LIGHT
TO BE ABLE TO START THE GENERATOR.
THE GENERATOR CANNOT BE STARTED DURING
BATTERY POWER SAVING MODE
UNLESS
1-2 Times
