Firman L03391, Owner'S Manual

Page: 22 / 120

Page 20 English Customer Service: 1-844-FIRMAN1
12. Allow generator to run at no load for few
minutes upon each initial start-up to permit
engine and generator to stablize.
See Indicator light - Battery power Saving
Mode section for more information.
When starting engine, pull cord slowly until resistance
is felt and then pull rapidly to avoid kickback.
Keep choke lever in “ START ” position for only 1
pull of the recoil starter. After first pull, move
choke lever to the “
RUN ” position for up to the
next 3 pulls of the recoil starter. Too much
choke leads to sparkplug fouling/engine
flooding due to the lack of incoming air. This
will cause the engine not to start.
WARNING
Starting the Generator (Electric Start-LPG)
1. Before starting the generator, check for loose
or missing parts and for any damage which
may have occurred during shipment.
2. Check oil level .
4. Fully open the LPG cylinder knob
.
3. Connect the regulator to both LPG cylinder and
generator.
NOTE
:
Do not place LPG cylinder in the path of muffler outlet
.
5. Disconnect all electrical loads from the
generator. Never start or stop the generator
with electrical devices plugged in or turned
on.
6. Move choke lever located on engine to “ START ”
position.
REMINDER: MUST HAVE SOLID RED INDICATOR
LIGHT TO BE ABLE TO START THE GENERATOR.
THE GENERATOR CANNOT BE STARTED DURING
BATTERY POWER SAVING MODE UNLESS
PULL THE STARTER CORD OR PUSH THE BATTERY
POWER RESTORE SWITCH.
7. Flip the engine switch to the "RUN"( l ) position.