Contact us for assistance: (866) 985-7877 | www.wtliving.com
6
ASSEMBlY
The
Waterbox
will be pre-assembled to the base. To fill, pull
open the plastic cap on top of the waterbox and fill with water
or sand. Place the plastic cap back on top. You may find it
easier to fill the waterbox prior to attaching wheels.
1
Attach
Wheel Assembly
K
to
Base
J
. Align holes to the
Base
, and insert 2
Small Bolts
N
through the holes and
finger tighten. Be sure that the
Wheel Assembly
is parallel to
the
Base
J
and tighten with the
Wrench
X
.
Hardware Used:
2x Small Bolts
N
2
Attach the
Post Supports
I
to the
Base
J
. Align the holes
in the bottom of each
Post Support
with the hole on the
Base
. Insert 1
Small Bolt
N
through the hole in the support and
into the
Base
and hand tighten. Repeat with the other 2
Post
Supports
and then tighten all bolts with the
Wrench
X
.
Hardware Used:
3x Small Bolts
N
Waterbox Cap
Base
PREPARATION
Before beginning assembly of this appliance, make sure all parts are present. Compare all parts with package contents list
and hardware contents as listed on page 4 of this manual. If any part is missing or damaged, do not attempt to assemble
this product. Contact customer service for replacement parts.
ESTIMATED ASSEMBlY TIME:
60 minutes
Tools Required for Assembly (NOT included):
• 7/16” open-end wrench
• Phillips screwdriver w/medium blade
• Adjustable wrench
• Leak test solution (see page 10)
Note: This heater has an Electronic Ignition and will require installation of 1 – AAA battery. The battery should be installed
by unscrewing the RED IGNITER BUTTON – battery not included.
