Contact us for assistance: (866) 985-7877 | www.wtliving.com
9
ASSEMBlY
9
While supporting heater, tilt the
Head Assembly
C
and slide 3
large Flat Washers
R
over the
Reflector
Studs
W
. Place the reflector assembly onto the
Reflector Studs
and slide 3
large Flat Washers
over the
Reflector Studs
and
onto the
Reflector Assembly
. Secure with 3
Wing Nuts
.
Once you have tightened the
Wing Nuts
, return the heater
to an upright position.
Hardware Used:
6x Large Flat Washer
B
3x Wing Nut
V
10
Connect the hose and regulator to the LP cylinder.
The LP cylinder is sold separately. Use a standard
9.07 kg / 20 lb propane cylinder
only
. Lift the
Tank Housing
D
up and rest it on the top of the assembled
Post Supports
I
.
Screw
Regulator
H
onto
Gas Hose
E
. Do not cross thread.
Hand tighten securely then tighten with the
Wrench
. Attach
the
Regulator
to the valve on the LP cylinder and hand tighten
securely. Place LP tank onto base of heater. Secure the
LPG tank by attaching the
Chain
L
onto the post supports.
Lower the
Tank Housing
.
NOTE: Use this heater only with a propane vapor withdrawal
supply system. See chapter 5 of the standard for storage and
handling of liquefied petroleum gas, ANSI/NFPA 58. Your local
library or fire department should have this book.