Firepower FP 95, Operating Manual

Page: 18 / 36

FIREPOWER FP 95 FC INSTALLATION
Manual 0-5122 3-4 Installation
WARNING
If ground connection clamp is in place
on the workpiece the electrode wire is
electrically “hot” when the gun switch is
activated.
5. Activate the gun switch until the wire feeds out past the
gun nozzle and deactivate the gun switch.
Contact Tip
Nozzle
Gun Switch
Wire
Art # A-09074
Figure 3-9: Feed Wire Through Gun
6. Set the Voltage Power Switch to "OFF" and unplug the
supply cord.
7. Replace the contact tip and nozzle. Cut the wire within
¼” (6mm) from the nozzle.
!
WARNING
The drive rollers, when moving, may crush
the fingers. Periodically, check the drive
rollers. Replace them when they are worn
and compromise the regular feeding of the
wire.
!
CAUTION
The Firepower FP 95 FC’s welding torch is
a “live” contact torch and is ALWAYS in the
power on position. Wear eye protection at
all times when handling this torch.
WARNING
ELECTRIC SHOCK CAN KILL! With the gun
switch (located on the gun) activated,
welding power is applied to the output
terminals, feedroll, ground clamp, gun
cable connection and welding wire. Do not
touch these parts while the gun switch is
activated.