54
Installation
(for qualified installers only)
© Travis Industries
4/22/21 - 1458
PB 72 MV/GSB2/GSR2 Install
Crushed Glass Installation
Do not allow the crushed glass to block the air slots or to become too thick (maximum 1
layer deep on the burner). Failure to properly install glass may lead to sooting and
improper burning.
If converting to LP (propane), convert the appliance prior to placing the crushed glass.
Install the crushed glass on the glass tray following the directions below.
Quantity of Crushed Glass
8 lbs. (3.6 Kg)
1 Remove the 16 screws that secure the media tray to the unit (see picture below – only showing one-half of
the tray due to length).
2 Remove the media tray from the unit to access the pilot assembly underneath. Remove the silicone sleeve
that is shipped on the spark electrode. Re-install the Media tray. Make sure that the setup pilot cover is
installed over the pilot assembly before adding glass
Remove (16) screws
(only ½ shown)
Center
of
Fireplace
Right
of
Fireplace
