Firenzo Athena Bay AG, Installation And Operation Handbook

Page: 21 / 22

Bay AG Installation 21
7. FASCIA ASSEMBLY & INSTALLATION
ATHENA WITH BAY DOOR
1 Remove screws fixed to lugs on firebox side.
2 Place pre assembled cast fascia against firebox and replace screw.
3 Remove 4 self tapping screws from below door opening and fit
ash hearth.
4 Fit lower grill over screws and tighten.
5 Set machine screw on top of bay section at approximately 30mm.
6 Place canopy lugs over the two 6mm screws in body and tighten.
7 The screw on the bay section may now require adjusting to support canopy.
8 Fit upper cast grill on side locaters.
9 Fit control knob
FORTE WITH BAY DOOR
1
Remove screws fixed to lugs on firebox side.
2 Place pre assembled fascia against firebox, position left hand slip
behind hinges and secure the screw. Place right hand slip against
fascia and secure.
3 Set the machine screw on the top of the bay section at approximately
30mm.
4 Place canopy lugs over the two 6mm screws in body and tighten.
5 The screw on the bay section may now require adjusting to support canopy.
6 Remove tape securing louvre.
7 Fit control knob.