REV. 10-18-19 Page 8
PAVER-CP-MT/ PAVER-CP-MSI
MT-MSI LIGHTING INSTRUCTIONS
Firegear Outdoors warrants the Paver Kit for 12 months from date of purchase or installation to original purchaser to be
free from defects in materials and workmanship. Damage to the Paver Kit caused by accident, misuse, abuse, or
installation error, whether performed by a contractor, service company, or owner, is not covered by this warranty.
Firegear Outdoors will not be responsible for labor charges and/or damage incurred in installation, repair, replacement, or
for incidental or consequential damage. Some states, provinces, and nations do not allow exclusion or limitations of
incidental or consequential damages, so the above limitations or exclusions may not apply. This warranty gives you
specific legal rights. You may also have other rights that vary by state, province, or nation.
LIMITED WARRANTY
Fig. 21.
Piezo button and key valve.
TURNING OFF FIRE PIT
1. Insert key and turn clockwise to OFF. Fire pit will turn OFF.
2. After cooling off install cover (if applicable).
READ ALL LIGHTING INSTRUCTIONS BEFORE ATTEMPTING TO LIGHT FIRE PIT
CAUTION
:
ENSURE YOU HAVE LEAK TESTED THE FIRE PIT BEFORE OPERATING.
WARNING: Do not stand over fire pit during ignition or operation due to high surface temperatures.
LIGHTING INSTRUCTIONS
TURNING ON FIRE PIT
1. Depress and hold the red Piezo ignitor button and ensure sparking is occurring at the probes inside ignition hood.
2. Insert key into gas valve and turn counter clockwise to the ON position.
3. After the fire pit lights release the Piezo button. If fire pit does not light within 30 seconds, turn key clockwise to turn
OFF and wait 5 minutes before trying again. Turn gas supply OFF to check probe spacing and Piezo battery if fire pit
does not light.
4. Repeat steps 1-4.
ON
OFF
AT ON POSITION
SLIGHT PUSH TO
TURN OFF
FULL PUSH TO
LIGHT
Red Piezo Button
Control Knob
ON OFF
Key Valve