REV. 10-18-19 Page 5
PAVER-CP-MT/ PAVER-CP-MSI
Step 1:
Remove the burner pan from the enclosure (if
applicable) or remove the fire pit from the carton.
Step 2:
Invert the burner pan up side down and remove
the four hex head screws from the cover plate. See Fig. 12.
Discard cover plate after removal.
Tools Needed:
Power Screwdriver with a
,
5
/
16
”
hex head
tip
or a
5
/
16
”
nut driver.
Power Screwdriver
Botto
m of
Pan
Cover Plate
Fig. 12
. Removing 4 cover plate screws.
CAUTION: Turn OFF main gas supply before installing.
PAVER-CP-MT-MSI INSTRUCTIONS
MT LIGHTING INSTRUCTIONS
Key
F
ig. 10
Inserting Key into Valve
ON
O
FF
Fig. 9
. Key Valve Face
Butane Ligh
ter
Fig. 11
Lighting fire pit with lighter
READ ALL WARNING AND SAFETY INFORMATION ABOVE BEFORE
ATTEMPTING TO LIGHT FIRE PIT
CAUTION
: ENSURE YOU HAVE LEAK TESTED THE FIRE PIT BEFORE OPERATING
TURNING ON FIRE PIT
1. Insert key into shut-off valve and secure into square end (see Figs 9-11).
2. Light a long match or butane lighter and hold it near the burner.
3. Turn the key slowly counter-clockwise in gas valve (until it stops) to allow gas to flow
and simultaneously apply the long burning match or Butane lighter as close to the end
burner as possible to light the fire pit.
4. Gas should ignite within 10 seconds or less. If fire pit does not light within 10 seconds
turn key clockwise to turn
OFF
the gas supply. Ensure there is not too much media on
top of the burner that might inhibit gas flow and try again in 5-minutes.
TURNING OFF FIRE PIT
1. Insert key into shut-off valve and secure into square end.
2. Turn key clockwise until it stops.
3. After cooling off install cover.