REV. 4-10-17 Page 5
MSI-BSMTI Kit
Key Valve
Gas Supply
Fire Pit Pan
ON
O
FF
Probe Assembly
Orange Wire
White Wire
Piezo Module
PIEZO23WH
PIEZO25WH
Fig. 10
Step #11:
Test the ignitor by pushing and holding the
red button to ensure the 2-probe ignitor is sparking inside
the ignition box in the burner pan. The spark should be
located directly overtop of the burner port hole for proper
ignition of the gas as previously discussed. Spacing
between the probes should be approximately 1/8” for
proper spark. See Fig. 5 if necessary.
Step #12:
. Install the ignition hood screen mesh and
ensure no media covers hood (See Fig. 11). Install
the lava rock/media material according to fire pit install
manual and turn the main gas supply back ON.
Installation is now complete.
Lava Rock
Lava Rock
Lava Rock
Ignition Hood
Screen Cover
Fig. 11
LIGHTING INSTRUCTIONS
READ ALL LIGHTING INSTRUCTIONS BEFORE ATTEMPTING TO LIGHT FIRE PIT
CAUTION
:
ENSURE YOU HAVE LEAK TESTED THE FIRE PIT BEFORE OPERATING.
WARNING: Do not stand over fire pit during ignition or operation due to high surface temperatures.
1. Push and hold the red button on the manual Piezo ignitor and ensure sparking is occurring at the probes inside fire pit.
2. At the same time turn
ON
gas supply.
3. Gas should ignite within 10 seconds or less. If fire pit does not light within 10 seconds turn
OFF
the gas supply. Check
ignitor probe location (Figs. 5 & 8), ensure there is an 1/8” gap between the probes with a good strong spark then
repeat steps 2 through 4.
4. Turn gas supply OFF to check probes and battery if fire pit does not light.
