REV. 4-10-17 Page 4
MSI-BSMTI Kit
Step #7
Install the ignition hood over top of the
ignition probe assembly into the existing prepunched holes
of the burner pan by using the five #10 - 24 x ½” provided
screws (See Fig. 8).
Step #8:
Install the mounting plate within 40-inches of the
2-probe Piezo ignitor. This will allow enough
“play”
in the
wires to make your connections.
The mounting plate can be installed using the template on
the back page of this manual. See Fig. 9 for details of
using template in concrete board and follow template
instructions on back page of this manual.
Step #9:
Connect the 3/16-inch extension wires into the
back side of the spark ignitor module. See Fig. 9 detail.
Step #10:
Attach the 1/4” extension wires (PIEZO23WH
& PIEZO25WH) to either of the ignition probe orange and
black spark ignitor wires (See Fig. 10).
Concrete Board
PIEZO25WH
PIEZO23WH
Fig. 8
ON
O
FF
Ready t
o Finish (R
TF)
Enclsour
e
Fig. 9
Close Up Detail
1/8”
Ignitor Probes
Ignition
Hood
Rainshield
Five #10-24 Screws
