Kalea Bay LED Outdoor Fireplace
REV. B Page 29
CAUTION
: Children and adults should be alerted to the hazards on high surface temperatures and should stay away to
avoid burns or clothing ignition. Young children should be carefully supervised when they are in the area of the appliance.
WARNING:
Do not use this appliance if any part has been under water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of control system and any gas control, that has been under water.
OPERATION
SAFETY WARNINGS
1. Never leave the fireplace unattended during operation.
2. Clothing or other flammable materials should not be placed on or near the appliance.
3. Any guard or other protective device removed for servicing the appliance must be replaced prior to operating the
appliance.
4. Installation and repair should be done by a qualified service person. The appliance should be inspected before
use and at least annually by a qualified service person. More frequent cleaning may be required as necessary. It
is imperative the control compartment, burners and circulating air passageways of the appliance be kept clean.
5. Inspect the fuel supply connection before each use of the appliance.
6. Temporary storage of this appliance indoors is permissible only if it has been disconnected from its fuel supply
(Natural or L.P. gas line).
WARNING
1. This appliance is hot when operated and can cause severe burns if contacted.
2. Do not burn any solid fuels in this appliance.
LIGHTING INSTRUCTIONS
READ ALL WARNING AND SAFETY INFORMATION ABOVE BEFORE ATTEMPTING TO LIGHT FIREPLACE
Turn
ON
main gas supply and check all fittings and connections for leaks with a soap and water solution.
Fig. 42
Control panel rocker switches.
RGB DIMMER
Mounting plate under switch cover
LED
ON/OFF
ON/OFF
LOW
HIGH
LEARN
CONT.
PILOT
5-5/8”
(143mm)
5-5/8”
(143mm)
HOW TO TURN ON
2. Push the “I” on the ON/OFF switch to turn ON (System
will take approximately 7-10 seconds before ignition
after the gas line is purged). During this time, an
“Ignition In-Process” beeping pattern will take place.
(e.g. one short beep, pause, three short beeps, pause;
repeated until ignition occurs). NOTE: Beeping pattern
may be difficult to hear outdoors.
3. The main flame ignites (defaults) in the HIGH position.
Press the “I” on the LOW/HIGH button to adjust to the
LOW setting.
4. A continuous pilot flame can be turned ON or OFF with
the continuous pilot button.
5. Push the “I” on the LED ON/OFF switch. LED’s will turn
ON. Adjust the intensity of the lighting by turning the
knobs clockwise on each dimmer knob. There
is infinite color combinations by adjusting the dimmer
knobs to personal taste.
HOW TO TURN OFF
1. To turn OFF the fireplace press the “O” position on
the ON/OFF switch. This will turn OFF the fireplace.
NOTE: Fireplace must be OFF for 5 minutes before
relighting.
To turn OFF the LED lights in the fireplace press the
“O” position on the LED ON/OFF switch. This will turn
OFF the LED lights. The LED lights are independent
of the fireplace and can be used when the fireplace is
not in operation.
“I” indicates Ignite/ON and “O” indicates OFF.
