Firefly Vegatouch Forest River Forester V1, Manual

Page: 7 / 37

7
Tap to Enable/Disable AGS. A warning message will require action to Enable.
Trigger Options – Automatically start the generator using specified voltage settings
(Low Volts) or when A/C or Heat starts (HVAC). Select one or both triggers. If no
triggers are selected, AGS will not run. Disable HVAC Load while connected to shore
power to keep the generator from starting.
Auto Gen Start (AGS) Settings
Quiet Time Start - Use the +/- buttons to select the starting point for Quiet Time, the
hours that your generator will not run in an effort to reduce noise.
Start at Volts - The generator will start when the voltage drops to this set point
depending on “Time a t Start Volts” setting below. (Range 10.5v – 12.5v)
Time at Start Volts - The generator will start when the voltage drops to the Start at
Voltage for this specific amount of time. (Range 5 seconds
– 1 minute) 5 seconds – 1
minute)
Stop at Volts - The generator will shut off when the voltage reaches this set point
depending on “Time at Stop Volts” setting below. (Range 13.2v – 14.5v)
Time at Stop Volts - The amount of time required for the voltage to remain at “Stop at
Volts” level before the generator shuts off. (Range 5min – 120min) 0min
Minimum Gen Run Time - Use the +/- buttons to set the minimum amount of time that
your generator will run once it has started. (Range 10min
– 30min) 0min – 30min)
Maximum Gen Run Time - Use the +/- buttons to set the maximum amount of time that
your generator will run once it has started. (Range 120min
– 720min)
(Range 120min – 240min)
– 30min)
Gen Start Retries - Use the +/- buttons to set the number of tries that your generator
will retry to start. (Range 1-5 retries)
– 30min)
Quiet Time Stop - Use the +/- buttons to select the stopping point for Quiet Time. AGS
will work normally at this point.