8
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
Figure 10
Figure 9
Step 1.
Carefully position the ceramic fiber
logs and twigs over the burner as shown in
Figures 9 and 10. Place the front log over two
pins located at either side of the front log
platform area, charred side forward. Position
the rear log over its pins in a similar fashion.
Figure 10 details the log set showing a front
view and top view of the single piece assembly.
Step 2.
Proper twig placement is critical to
prevent sooting. Refer to
Figure 10 and place
the twigs as shown. Twigs should be placed in
the gaps between the flame peaks and should
be positioned so that at no time they impinge
the flames.
Step 3.
Remove the rockwool from the pack-
aging and tear into nickle size pieces (
Figure
11 ). Spread along the front edge of the front
burner. Do not use more than is necessary.
When properly positioned, the rockwool will
unevenly cover approximately 85% of the gap
between the front burner and the grate front
face with no appreciable openings.
Figure 11
WARNING: THE SIZE AND POSITION ON
THE LOG SET WAS ENGINEERED TO GIVE
YOUR APPLIANCE A SAFE, RELIABLE
AND ATTRACTIVE FLAME PATTERN. ANY
ATTEMPT TO USE A DIFFERENT LOG SET
IN THE FIREPLACE WILL VOID THE WAR-
RANTY AND WILL RESULT IN INCOM-
PLETE COMBUSTION, SOOTING, AND
POOR FLAME QUALITY.
WARNING: LOGS GET VERY HOT AND
WILL REMAIN HOT UP TO ONE HOUR
AFTER GAS SUPPLY IS TURNED OFF.
HANDLE ONLY WHEN LOGS ARE COOL.
TURN OFF ALL ELECTRICITY TO THE
APPLIANCE BEFORE YOU INSTALL
GRATE AND LOGS.
WARNING: THIS APPLIANCE IS NOT
MEANT TO BURN WOOD. ANY ATTEMPT
TO DO SO COULD CAUSE IRREPARABLE
DAMAGE TO YOUR APPLIANCE AND
PROVE HAZARDOUS TO YOUR SAFETY.
Logs and Rockwool Placement
TOP
FRONT
c.
d.
e.
a.
b.
