2
1.0 INTRODUCTION
We would like to thank you for purchasing a high efficiency, Firebird multifuel backboiler
inset stove (hereinafter referred to as “the inset stove”). The design for this product stems
from our original concept, “the Firebird backboiler”. The stove is manufactured in its entirety
in our factory in Baile Mhic Íre, Macroom, Co. Cork, using the highest standard of
workmanship and latest technology.
This instruction manual has been produced for the reference and guidance of qualified
installation technicians.
You should ensure that all installation, servicing and commissioning works are carried out
by a HETAS approved or competent, qualified engineer. It should be noted that it is the
responsibility of the installer/householder to ensure that the inset stove is properly
commissioned. Failure to do so may invalidate the warranty.
2.0 IMPORTANT SAFETY NOTES
• The term multifuel refers to commercially available solid fuels such as wood, smokeless
coal and anthracite. The appliance shall not be used as an incinerator; only recommended
fuels shall be used. Liquid fuels should never be used when lighting or filling the fire.
• THIS INSET STOVE SHOULD ONLY BE INSTALLED IN OPEN VENTED SYSTEMS.
• Do not store liquid fuels in close proximity to the inset stove.
• The inset stove is designed in such a way, that under normal burning conditions, the
fumes pass up through the chimney flue and do not escape into the home. Please ensure
that the flue system is checked regularly, that no cracks or openings are evident and that
the seals on the inset stove are in good condition.
• ENSURE THE BAFFLES ARE ALWAYS IN PLACE WHEN LIGHTING THE INSET STOVE AND
NEVER LIGHT A FIRE IF THE BAFFLES ARE NOT IN PLACE.
• THE INSET STOVE DOOR SHOULD NOT BE KEPT OPEN WHEN THE FIRE IS LIT/ BURNING.
• The inset stove should never be over stocked/over filled. The draught settings should be
reduced if this occurs.
• A mechanical air supply should never be added to the inset stove.
• The inset stove reaches high temperatures and can be hot to touch. Ensure that safety
guards (in accordance with BS8423:2002) are in place.
• Do not place any furniture or combustible material within 800mm of the inset stove.
• Please ensure that operating tools are used where provided. The stove becomes very hot
during operation and should not be touched with bare hands.
• Ensure that BS8303, code of practice for installation of domestic heating and cooking
appliances burning solid mineral fuel, is adhered to at all times.
• Aerosols should not be sprayed near the appliance while alight.
• Ensure the following codes and standards are adhered to:
- BS EN 15287 - 1:2007 design, installation and commissioning of chimneys.
- BS EN 14336:2004 heating systems in buildings.
- Installation and commissioning of water based heating systems.
- BS EN 12828:2003 heating systems in buildings.
- Design of water based heating systems.
- BS EN 12831:2003 heating systems in buildings.
- Method of calculation of the design heat load.
• Please read this manual carefully prior to installation of the inset stove.
• All local regulations, including those referring to national and European standards,
need to be complied with when installing the applicance.
