9
Learn button
LED
HOW TO ‘LEARN-IN’ THE ALARM CONTROL
UNIT TO A WI-SAFE 2 NETWORK:
1. Using a ballpoint pen, briefly push and
release the 'learn button' on the back of the
control unit. The red LED next to the learn
button will flash briefly then light up for
approximately 5 seconds.
2. During these 5 seconds you need to briefly
press the test button on an alarm already in
the network, to wirelessly interlink the two.
The alarm will sound its audible test pattern.
3. The red LED on the back of the control
unit will flash to indicate that it has been
‘learned-in’ successfully. If the test button
is not pressed quickly enough, the ‘learn-
in’ process will fail. If this happens, repeat
the process.
Your Alarm Control Unit counts as one unit within
the network. If it is installed retrospectively, then
the existing network cannot exceed 49 units in
size.
