Contact us for assistance: (866) 985-7877 | www.
balkenehome.com
7
ASSEMBLY
5
Assemble Reflector.
Note: Remove protective plastic film on
reflector pieces prior to assembling.
6
CAUTION: be careful when using a ladder or step-stool.
Sl
ide
the assembled Reflector onto the reflector studs in the top of
the Head Assembly. Place a
n
M8
Washer
on each of the
Reflector
Studs
. Secure with 3
Wing Nuts
and hand-tighten.
Hardware Used:
3
-
M8
Washer
3
-
Wing Nut
Connect the hose and regulator (from natural gas company) to
the natural gas outlet. The natural gas is obtained from your
Assembly tip: if necessary for proper alignment of reflector
sections, loosen each screw prior to further assembly and re-
tighten after sections are aligned.
Reflector Panels
A
come packaged in two brown boxes with two
panels in each box. Hardware for assembly is already affixed to
each panel. Place two panels side by side and remove the two cap
nuts and washers that are affixed to one panel. Insert the affixed
bolts into the open holes on the adjacent panel. Place the washer
over the bolt and screw on cap nut. Repeat these steps until all four
panels are assembled. Then locate the
Reflector Center Cap
B
. You
will need to remove the cap nuts and washers located at the top of
each Reflector Panel to allow assembly of the
Center Cap
to
each
panel. Align the holes in the
Center Cap
with the bolts on each
Panel
and affix washer and cap nut to complete assembly.
7
natural gas supply company. Use a
standard 7” WC natural gas only.
NOTE:
the fitting provided with the heater is size 3/8" and should
be connected to a compatible 3/8" fitting from the natural gas
source.
