Audio Command Center Series Manual —
P/N 51889:E1 6/8/2010
65
Switch Functions
Operating Instructions
8. Press and release the push-button on the keypad (Message 1 to Message 5) associated with the
voice message that will be changed. The selected Message push-button will illuminate steady
and all others will extinguish.
9. The green LED on the Record/Playback push-button will continue flashing. If recording
doesn’t begin within 10 seconds, the record operation will be terminated.
10. Begin recording a message by using one of the following methods, depending on the setting of
S5 DIP switch 7 in step 3:
• press the microphone key switch and speak into the microphone
OR
• press and release the selected message push-button a second time to record from either of
the External Audio Input jack sources
11. The selected message push-button and Record/Playback LEDs will turn on steady during
recording process
12. Upon completion of the message, to terminate recording of the current message:
• release the microphone key switch
OR
• press and release the selected message push-button
13. To record additional messages, repeat steps 7 through 11
14. To terminate the recording process, press and release the Record/Playback push-button. The
Record/Playback LED will extinguish and the panel will return to normal.
15. Disable the record function by setting S5 DIP switch 8 to the OFF position. The Record/Play-
back push-button is now ready to be used for local playback.
16. Slide the Record Bypass switch S2 to the DOWN position to disable the message storage
device.
4.1.6 Record/Playback Button - Review Stored Message(s)
The Playback push-button can be used to review the stored voice message(s). By connecting the
optional Local Playback Speaker Module, the message can be heard without transmitting it over the
system speakers. The system must be in standby with not activity in order to begin playback oper-
ation. Refer to
and
for switch locations.
To playback a message over the local speaker:
1. Make certain that S5 DIP switch 8 is in the OFF position to allow the Record/Playback push-
button to be used for message playback.
2. Press and release the Record/Playback button.
3. Record/Playback LED will turn on steady and the Message push-button that contain messages
will flash at a ½ second rate. Playback operation is terminated if step 3 does not occur within
10 seconds or if the system is alarm activated.
4. Press and release one of the flashing Message push-buttons to hear one cycle of the selected
message. The selected push-button LED will illuminate steady during playback while the
other Message LEDs will continue to flash.
5. Repeat step 3 to listen to any of the other stored messages.
!
CAUTION:
REPLACE SWITCHES
BE CERTAIN TO SLIDE THE RECORD BYPASS SWITCH S2 TO THE DOWN POSITION WHEN
RECORDING IS COMPLETED. THIS WILL PREVENT ACCIDENTAL RERECORDING OR DELE-
TION OF THE STORED MESSAGE(S). IT IS NOT POSSIBLE TO RECORD WITH THE S2
RECORD BYPASS SWITCH IN THE DOWN POSITION. ALSO PLACE S5 DIP SWITCH 8 IN THE
OFF POSITION TO ALLOW THE RECORD/PLAYBACK PUSH-BUTTON TO BE USED FOR MES-
SAGE PLAYBACK.
